The USB 2.0 IDE Adatper implements a bridge between a USB port and an ATA-or
ATAPI-based mass storage device port. This bridge adheres to the Mass Storage
Class Bulk-Only Transport Specification. Hardware design allows CBW command
queuing, which allows data transfer rates up to the USB theoretical maximum
with vendor specific drivers.
 
Complies with USB-IF sepcifications for USB 2.0,the  USB Mass Storage
      class,and the USB Mass storage Class Bulk-Only Transport Specification
     
Operates at high (480-Mbit)or full (12-Mbit)speed
   
  Complies with ATA/ATAPI-6 specification
   
  Supports 48-bit addressing for large hard drives
     
  Supports PIO modes 0,3,4 and UDMA modes 2,4
 
ATA interface IRQ signal support
 
Support for a single ATA/ATAPI device configured either at master or slave
      mode
 
  U2IDE3M-BL